Resistor color code calculator
Pick the band colors in order, starting from the band closest to one end of the resistor. The tool reads the value, tolerance and (for six bands) the temperature coefficient.
Reverse lookup: value to colors
How the numbers are worked out
The colors follow IEC 60062, as tabulated on Wikipedia’s Electronic color code page. Black to white stand for digits 0 to 9. A 4-band resistor has two digits, a multiplier and a tolerance; a 5-band or 6-band resistor has three digits, a multiplier and a tolerance, and the 6-band adds a temperature coefficient in ppm per kelvin. The multiplier band gives the power of ten, with gold meaning ×0.1 and silver ×0.01. With no tolerance band the standard gives ±20%. A resistor can be read from either end, so confirm the direction: the tolerance band is usually set slightly apart from the others, and gold or silver is typically on the tolerance end. Real parts do not always follow the four-or-five-band rule, so measuring with a multimeter settles any doubt.
Worked examples: resistor bands
Four bands, green-blue-red-gold: digits 5 and 6, multiplier ×100, so 5,600 Ω with a gold tolerance of ±5%. The real value then lies between 5,320 Ω and 5,880 Ω.
Four bands, yellow-violet-red-gold: digits 4 and 7, multiplier ×100, giving 4,700 Ω (4.7 kΩ) at ±5%, or 4,465 Ω to 4,935 Ω.
Five bands, green-purple-black-red: three digits 5, 6, 0 make 560, and the red multiplier ×100 gives 56,000 Ω, or 56 kΩ, before the tolerance band is applied.
Reading direction
The first band is the one closest to an axial lead. The tolerance band usually sits slightly apart from the digit bands, and gold or silver at one end marks that end as the tolerance side. Exceptions exist: five-band parts with a gold or silver fourth band appear on specialized and older resistors.
Where the code comes from
The colors were codified by the International Electrotechnical Commission in 1952 as IEC 62, now IEC 60062, and adopted as EIA RS-279 in 1963. The standard also covers numeric marking codes used on surface-mount parts. A three-band resistor has no tolerance band, which the standard reads as ±20%, and a single black band marks a zero-ohm link.
Limits
- Color shades fade or look alike under poor light, particularly brown, red and orange, and blue and violet.
- Resistors above one watt and most surface-mount parts use printed numbers, not bands.
- Measuring with a multimeter, out of circuit, settles any doubt.
Common questions
What does no fourth band mean? A tolerance of ±20%.
Why do five-band resistors cost more? They are typically built to tighter tolerances such as ±1%.
Related tools
Ohm’s law calculator and all free tools.
